shower head-开平市瑞霖淋浴科技有限公司 Location:Home » News » Entreprise's news
Entreprise's news
Installation and precautions of shower head!
Addtime: 2021-12-27
Clicks:25764
Tags:shower head

1. The distance between the hot and cold water outlets is 13-15/cm and is parallel and vertical. The thermostatic shower requires that the water outlets must be hot on the left and cold on the right. The water outlet cannot be recessed into the tile surface more than 0.5cm.

2. Drain the water for 15 seconds to clean the silt and impurities in the pipeline to avoid clogging the valve core.

3. When installing the main body, pay attention to check whether there is a 6-point sealing water gasket. When fixing the nut, a cloth must be used to prevent scratches on the surface.

4. Open the water valve, check whether there is any water leakage at the joint of the curved angle, and the water flow of the main body.

5. When drilling holes on the fixed pole, you must ask the customer whether there are water pipes and wires in the hole location to avoid breaking the pipeline and causing unnecessary losses.

6. When inserting the vertical pole, pay attention to whether the water sealing O-ring is deformed, and the overlap of the two pipes should be deep enough to prevent the overlap from being too short to cause water leakage.

shower head

7. Tighten the pull screws of the pole to prevent excessive water pressure from rushing out of the pole and damaging the ceiling of the customer's home.

8. After installation, you must check again whether there is water leakage at each interface.

After purchasing a shower, bathtub, or wall-mounted faucet, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must be 15 cm. Don't forget to flush the water pipe before installation to prevent the water from being too hard and causing damage to the faucet. If the elbow between the faucet and the wall joint is too long, a part of the 4-point end can be cut off. Remember that the 6-point connection with the faucet cannot be cut randomly. After purchasing a concealed faucet, the valve core of the faucet is generally pre-buried in the wall. The above is the shower installation and precautions introduced by Ruilin Shower. I hope it will be helpful to everyone!

(Some materials on this website come from the Internet. If the information displayed on this website infringes your copyright or other legal rights, please notify us in time, and this website will be deleted in time.)


Copyright © 开平市瑞霖淋浴科技有限公司  

Technical :

粤ICP备2021069590号